DRYER REPAIR
No heat or insufficient heat
Caused by a failed heating element, thermostat, or thermal fuse.
Takes too long to dry
A clogged vent, overloaded drum, or faulty thermostat/relay board.
Clothes come out damaged or burned
Overheating due to defective controls or using the wrong cycle.
Loud noises
Worn belts, drum rollers, idler pulleys, or bearings cause squealing.
Drum turns but there’s no heat
Broken belt, bad motor, or blown thermal fuse.
Drum doesn’t spin
Faulty drive belt, motor, or control board.
Won’t start or stops immediately
Door switch, fuse, or control board failure.
Overheats and shuts down; burning smell
Obstructed lint trap or vent system.
Runs continuously and doesn’t shut off
Defective timer or control board.
Door seal problems or latch issues.
Sensor errors or moisture sensor failures.
Excess vibration or “walking”. Uneven floor or worn suspension.
Sparks/electrical issues
Damaged wiring demands immediate service.
Schedule Appointment
Diagnostic service is only $50. The fee is applied toward the repair if you proceed.
11130 Otsego St,
North Hollywood,
CA 91601,
USA
Monday - Saturday: 08:00 AM - 06:00 PM